Maintenance - Blade Changing
197
Pos: 99.27 /Überschr iften/Überschrif ten 3/K-O/Messerschnel lverschluß @ 0\mod_11972 71019859_78.doc x @ 16597 @ 3 @ 1
19.2.2 Blade Quick-Fit Device
Pos: 99.28 /BA/W artung/Mähwerke/Messersc hraub / Messerschne llverschluss/Besc hreibung Messerwechse l Messerschnell verschluss @ 0\mod_1197271 100500_78.doc x @ 16616 @ @ 1
EC-251-0
3 4
2
5
Fig. 129
• Clean the area.
• Remove damaged or worn blades.
• Push the special tool (1) {blade key} between the cutter disc (4) and leaf spring (3) and
press down with one hand.
• Guide a new blade (2) onto the retaining bolt and allow the blade key to return upwards.
• After fitting the blades, fold the protective device down again.
Note
• The cutter blades of anticlockwise rotating cutting discs / blade drums are different than
those of clockwise rotating ones. Make certain the direction of rotation is correct when
installing!
• The arrow on the cutter blades must match the direction of rotation of the corresponding
cutting discs / blade drums.
• The hex nut (4) used to secure the retaining bolts must not be used more than once.
Order No. for clockwise rotating blade: 139-889
Order No. for anticlockwise rotating blade: 139-888
Pos: 99.29 /Layout Module /---------------Seitenumbruc h---------------- @ 0\mod_1196175311226_0.docx @ 4165 @ @ 1
To Next Page
Loading...
