Maintenance – lubrication chart
199
Pos: 102.1 /Überschr iften/Überschrif ten 1/U-Z/Wartung - Sc hmierplan @ 0\mod_119735930 4198_78.docx @ 18232 @ 1 @ 1
20 Maintenance – lubrication chart
Pos: 102.2 /Überschr iften/Überschrif ten 2/P-T/Spezielle Sic herheitshinweise @ 0\ mod_1196660495760_78. docx @ 9134 @ 2 @ 1
20.1 Special Safety Instructions
Pos: 102.3 /BA/Sic herheit/7. Gefahrenhin weise alt/Mähwerke/ Gefahr - Reparatur_W artung_Reinigungs_4 a llgemein EasyCut (2014- 09-17 10:10:25) @ 11\ mod_1223620198301_78. docx @ 148349 @ @ 1
Danger! - When performing repair, maintenance or cleaning work on the machine, or in
the case of technical intervention, drive elements may start moving (caution, the cutting
discs continue to run).
Effect: Danger to life, injuries or damage to the machine.
• Move the machine to the working position and lower it to the ground
• Switch off the tractor engine and remove the ignition key.
• Secure the tractor against accidental start-up and against rolling.
• Switch off the PTO and disengage it.
• After repair, maintenance, cleaning work or technical modifications are complete, mount all
protective coverings and safety devices again properly.
• Avoid skin contact with oils, greases, cleaning agents and solvents.
• In the event of injuries or burns due to oils, cleaning agents or solvents, contact a doctor
immediately.
• All other safety instructions must also be followed to avoid injuries and accidents.
Pos: 102.4 /Überschr iften/Überschrif ten 2/F-J/Gelenkwel le @ 0\mod_1199781879794_ 78.docx @ 34542 @ 2 @ 1
20.2 PTO shaft
Pos: 102.5 /BA/W artung/Gelenkwelle schmier en/Abschmieren Gele nkwelle EasyCut 100 h / 250 h @ 44\ mod_1275544870187_78. docx @ 392086 @ @ 1
Fig. 132
Lubricate the PTO shafts at the intervals indicated in the drawing with a multi-purpose grease.
Follow the operating instructions of the PTO shaft manufacturer.
Pos: 102.6 /Layout Module / ---------------Seitenumbruch---------------- @ 0\mod_1196175311226_0.docx @ 416 5 @ @ 1
To Next Page
Loading...
