Special equipment
213
Pos: 118.1 /Überschr iften/Überschrif ten 1/P-T/Sonderausst attung @ 2\mod_1202808 469779_78.docx @ 61649 @ 1 @ 1
22 Special equipment
Pos: 118.2 /Überschr iften/Überschrif ten 2/P-T/Spezielle Sic herheitshinweise @ 0\ mod_1196660495760_78. docx @ 9134 @ 2 @ 1
22.1 Special Safety Instructions
Pos: 118.3 /BA/Sic herheit/7. Gefahrenhin weise alt/Mähwerke/ Gefahr - Reparatur_W artung_Reinigungs_4 a llgemein EasyCut (2014- 09-17 10:10:25) @ 11\ mod_1223620198301_78. docx @ 148349 @ @ 1
Danger! - When performing repair, maintenance or cleaning work on the machine, or in
the case of technical intervention, drive elements may start moving (caution, the cutting
discs continue to run).
Effect: Danger to life, injuries or damage to the machine.
• Move the machine to the working position and lower it to the ground
• Switch off the tractor engine and remove the ignition key.
• Secure the tractor against accidental start-up and against rolling.
• Switch off the PTO and disengage it.
• After repair, maintenance, cleaning work or technical modifications are complete, mount all
protective coverings and safety devices again properly.
• Avoid skin contact with oils, greases, cleaning agents and solvents.
• In the event of injuries or burns due to oils, cleaning agents or solvents, contact a doctor
immediately.
• All other safety instructions must also be followed to avoid injuries and accidents.
Pos: 118.4 /BA/Sonderaus statung/EasyCu t / AM Mähwerke/Hochschnit tkufen EasyCut @ 3\mod_12 04783761105_78.doc x @ 72974 @ 2 @ 1
22.2 Adjusting Skids
1
3
EC-192-1
2
Fig. 141
Adjusting skids can be used to increase the cutting height (see chapter entitled "Adjusting the
cutting height")
To do this, insert the adjusting skids (3) into the glide skids (2) and screw them in place. The
adjusting skids must always be mounted underneath the mowing discs that run next to the
mower drum.
Pos: 119 /Layout Module /---------------Seitenumbruch--------------- - @ 0\mod_1196175311226_0.doc x @ 4165 @ @ 1
To Next Page
Loading...
