Krone EasyCut B 1000 CV - Connecting Terminal to ISOBUS Tractors

KRONE ISOBUS-Terminal CCI 100
50
Pos: 61.14 /BA/Inf o-Center/CCI-I SOBUS-Terminal/Terminal ansc hließen (vorgerüs teteter ISO Schlepper) @ 172\mod_1370518477799_ 78.docx @ 1480570 @ 3 @ 1
8.2.2 Connecting the Terminal (on tractors with integrated ISOBUS system)
6
5
1
2
3
4
CC00014
1
4
7
3
6
9
7
9
10
11
13
12
5
14
8
Fig. 24
Connection terminal to tractor
Note
The terminal is connected to the tractor via a special cable set (5) which can be ordered by
stating the KRONE article no. 20 081 223 0.
• Connect plug (2) of cable set (5) with socket (1) (CAN1-IN) of the terminal.
• Connect plug (4) of cable set (5) with socket (3) (CAN1-out) of the terminal.
• Connect ISO plug (6) (9-pole) of cable set (5) with the ISO socket (7) (9-pole) located in the
tractor cabin.
Connection tractor to machine
Note
The tractor is connected to the machine via cable set (14) which can be ordered by stating
KRONE article no. 20 080 384 0.
• Connect ISO-plug (9) (9-pole) of cable set (14) with the outer ISO socket (8) (9-pole) on
tractor side.
• Connect plug (10) (7-pole) of cable set (14) with socket (11) (7-pole) of the machine.
• Connect plug (12) (2-pole) of cable set (14) with socket (13) (2-pole) of the machine.
Pos: 61.15 /Layout Module /---------------Seitenumbruc h---------------- @ 0\mod_1196175311226_0.docx @ 4165 @ @ 1