Krone EasyCut B 1000 CV - Switching the Terminal on; off When the Machine Is Not Connected

KRONE ISOBUS-Terminal CCI 100
54
Pos: 61.25 /Überschr iften/Überschrif ten 3/A-E/E/Ein- Ausschalten des Terminals bei nicht angeschlossen er Maschine @ 43\mod_1275 290766562_78.doc x @ 389835 @ 3 @ 1
8.2.6 Switching the terminal on / off when the machine is not connected
Pos: 61.26 /BA/Inf o-Center/CCI-I SOBUS-Terminal/CCI-BiG Pac k/Ein- Ausschalten Bi ld mit nicht angeschlos sener Maschine @ 43\mod_1 275291241781_78.doc x @ 389860 @ @ 1
Fig. 28
Pos: 61.27 /BA/Inf o-Center/CCI-I SOBUS-Terminal/Ein- Aussc halten des Terminal´s/ Hinweis Bevor Sie das Ter minal zum ersten Mal... @ 43\mod_1273657536203 _78.docx @ 384008 @ @ 1
Note
Before switching the terminal on for the first time make sure that the connections on the device
are fastened right and securely.
By pressing and holding (for approx. 2 sec.) the key (1)
(ON/OFF) the terminal will be
switched on or off.
Pos: 61.28 /BA/Inf o-Center/CCI-I SOBUS-Terminal/Ein- Ausscha lten des Terminal´s/ Hinweis Für weitere Anga ben zur Funktionsweise Ha ndbuch beachten @ 47\mod _1285155240781_78.doc x @ 455819 @ @ 1
Note
For further information on the functioning of the ISOBUS terminal CCI refer to the terminal
operating instructions included with delivery.
Betriebsanleitung
Version: 1.0
CC-ISOBUS
ISOBUS-Terminal CCI 100/200
Fig. 29
Pos: 61.29 /Layout Module /---------------Seitenumbruc h---------------- @ 0\mod_1196175311226_0.docx @ 4165 @ @ 1