KRONE ISOBUS CCI 100 Terminal / manual mode
68
Pos: 61.39.5.13 /BA/ Info-Center/CCI -ISOBUS-Terminal/CCI- EasyCut/EasyCut B 1000/ Grundbild Mähwerke heb en/senkenGrundbild Mähwerke heben/senken heb en (2014-10-07 14:17: 13) @ 93\mod_13270628919 01_78.docx @ 786399 @ @ 1
Fig. 39
Pos: 61.39.5.14 /BA/ Info-Center/CCI -ISOBUS-Terminal/CCI- EasyCut/EasyCut B 1000/ Grundbild Mähwerke heb en/senkenAnheben al ler Mähwerke von Arbei tsstellung in Vorgewendes tellung abhängig vom Menü 1-7 (2014-10-07 13: 46:53) @ 180\mod_1375874566 470_78.docx @ 1541671 @ 3 @ 1
9.3.5 Raising All Mowing Units from Working Position to Headland Position
Raising the lateral mowing units to the front mowing unit depends on the set mode in menu 1-7
“Setting Manual Control/Distance Control/Time Control”.
In mode 1 manual control
• Press and hold the function key for
to raise the front mowing unit.
• Release the function key for
to raise the lateral mowing units.
In mode 2 time control and mode 3 distance control
• Press and release the function key for
to raise the front mowing unit and the lateral
mowing units.
The lateral mowing units are raised after the set time delay and the set distance have been
reached.
Note
The lateral mowing units are raised directly into headland position if there is no front mowing
unit installed.
Pos: 61.39.5.15 /BA/ Info-Center/CCI -ISOBUS-Terminal/CCI- EasyCut/EasyCut B 1000/ Grundbild Mähwerke heb en/senkenAnheben der Setenmähwerke von Vorge wende in Transportste llung (2014-10-07 13:49: 46) @ 93\mod_1327308206 446_78.docx @ 786666 @ 3 @ 1
9.3.6 Raising the lateral mowing units from headland to transport position
Pressing the function key for
and keeping it pressed raises the two lateral mowing units to
the transport position.
Pos: 61.39.6 /Layout Module /---------------Seitenumbruch---------------- @ 0\mod_1196175311226_0.doc x @ 4165 @ @ 1
To Next Page
Loading...
