Krone EasyCut B 870 CV Collect - Adjusting the Tedder Speed

Settings
63
Pos: 119.21 /Übersc hriften/Überschr iften 2/A-E/Einstel lung der Zetterdrehzahl @ 0\ mod_1196668564463_78. docx @ 10266 @ 2 @ 1
11.4 Adjusting the Tedder Speed
Pos: 119.22 /Abkürzu ngen /CV-Ausführung @ 95\ mod_1328530180147_78. docx @ 799128 @ @ 1
CV-Design
Pos: 119.23 /BA/Sic herheit/7. Gefahrenhin weise alt/Einste llarbeiten / Einstellu ngen/Gefahr - Einste llungen an der Maschine @ 0\ mod_1196668628056_78.d ocx @ 10285 @ @ 1
Danger! - Settings on the machine
Effect: Danger to life, injuries or damage to the machine.
• Setting tasks must only be performed when the drive is switched off and the engine is at a
standstill! Remove the ignition key!
Pos: 119.24 /BA/Einste llungen/Mähwer ke/Zetterdrehzahl/ Zetterdrehzahl Bild EC B 1000 C V/ 3600/ 3201/ BM 500/ BM42 0 Frontmähwerk/ (600/ 900) @ 210\mod_1389161970 831_78.docx @ 1730615 @ @ 1
EC-466-0
600
900
3
1
2
Fig. 29
Pos: 119.25 /BA/Einste llungen/Mähwer ke/Zetterdrehzahl/ Zetterdrehzahl eins tellen 600/900 @ 11\mod_12 23613453645_78.doc x @ 148195 @ @ 1
Two tedder speeds can be set on the speed gearbox. This affects the conditioning effect and
the power consumption.
Minimum speed: 600 rpm.
Maximum speed: 900 rpm.
• Unscrew the wing screw (1) from the actuating lever (2).
• Rotate the actuating lever (2) 180°. In doing so, turn the mower drum (3) so that the
actuating lever can be rotated completely.
• Secure the actuating lever (2) with the wing screw (1).
Pos: 119.26 /Layout Mod ule /---------- -----Seitenumbruc h------------- --- @ 0\mod_1196175311226_ 0.docx @ 4165 @ @ 1