Maintenance - Cutterbar 14
Checking/replacing linings on cutterbar 14.7
Original Operating Instructions 150000802_00_en 73
KM000-081
Open the welding seams of the old impact stop.
Remove the impact stop.
Deburr the contact surfaces.
KM000-080
Fit the new impact stop (3).
Weld short I seams on the upper surface of the cutterbar in the areas marked (1) (each
approx. 30 mm). INFO: Do not weld the edges (2).
On the lower surface of the cutterbar, weld the impact stop (3) to the cutterbar along the
whole length in area (5). INFO: Do not weld the edges (4).
To Next Page
Loading...
