Krone Swadro 1000 - Operational Readiness; Settings

Medium Control Unit
34
Pos: 21.14 /BA/I nfo-Center/Schw ader/Bedienein heit- M edium/ Swadro 1000/B etriebsbereitsch aft @ 2\mod_12 03312466340_ 78.docx @ 6 5196 @ 2 @ 1
6.5 Operational Readiness
• Turn on the medium control unit at the main switch.
Press the key
A brief self-test follows provided the electrical power supply has been properly connected. All
pilot lights (LED on) of the control panel are briefly lit and a horn sounds a short signal.
Pos: 21.15 /Übersc hriften/Überschrif ten 3/P-T/Se nsorkontrolll euchten @ 2\ mod_1203313367 371_78.doc x@ 6 5235 @ 3 @ 1
6.5.1 Sensor pilot lights
Pos: 21.16 /BA/I nfo-Center/Schw ader/Bedienein heit- M edium/ Swadro 1000/S ensorkontrollleuc hten Bild SW 1 000 @ 2\mod_ 12033134345 58_78.docx @ 6 5303 @ @ 1
SW1000029
Figure 12
Pos: 21.17 /BA/I nfo-Center/Schw ader/Bedienein heit- M edium/ Swadro 1000/S ensorkontrollleuc hten Text @ 2\mod_12033 12942543_78.d ocx @ 65254 @ @ 1
The diodes of the corresponding rotors (11) indicate whether the sensors are alive (iron in front
of the sensor).
LED on: Iron in front of the sensor
LED off: No iron in front of the sensor
LED flashing: Sensor has broken cable or short circuit
Pos: 21.18 /BA/I nfo-Center/Schw ader/Bedienein heit- M edium/ Swadro 1000/Kr eisel für eine Fu nktion vorwä hlen @ 2\mod_12 03313671715 _78.docx @ 65 322 @ 23 @ 1
6.6 Settings
6.6.1 Selecting the Rotors for a Function
By using keys and the rotors are selected for the function which needs to be
performed (depending on the equipment on the machine and the selected function).
LED on: Rotor selected
LED off: Rotor not selected
Pos: 21.19 /BA/--- ------ ------Seitenumbruch---- ------------ @ 0\m od_1196175311 226_0.docx @ 4 165 @ @ 1