Krone Swadro 1000 - Eliminating Alarm Messages

Medium Control Unit
44
Pos: 21.42 /BA/I nfo-Center/Schw ader/Bedienein heit- M edium/ Swadro 1000/Al armmeldunge n beheben @ 2\m od_120332591 0168_78.docx @ 65708 @ 2 @ 1
6.16 Eliminating Alarm Messages
If an error has been detected by the electronic system, it must be eliminated. If there is no more
alarm present after switching off and then switching back on again, that state will be indicated
by a continuous light on the key (Symbol ON/ OFF).
Pos: 21.43 /Übersc hriften/Überschrif ten 2/A-E/A nzeigen der Sof tware-Version @2 \mod_12 03326630699_7 8.docx @ 65766 @ 2 @ 1
6.17 Displaying the Software Version
Pos: 21.44 /BA/I nfo-Center/Schw ader/Bedienein heit- M edium/ Swadro 1000/A nzeigen der So ftware-Version Bil d @ 2\mod_ 1203326682121_ 78.docx @ 657 85 @ @ 1
SW1000034
(I)
(II)
Figure 21
Pos: 21.45 /BA/I nfo-Center/Schw ader/Bedienein heit- M edium/ Swadro 1000/A nzeigen der So ftware-Version T ext @ 2\mod_1 20332601207 4_78.docx @ 657 27@ @ 1
To display the software version of the machine, press the key 10 times.
I ) Position (I) indicates the tens component of the software version.
For example, with software version 20, two LEDs are lit; with software version 40, four LEDs are
lit.
II ) Position (II) indicates the components of the software version.
For example, with software version 2, two LEDs are lit; with software version 5, five LEDs are lit.
Following is an example of software versions.
Software Version 25
= Position (I) (2 LEDs are lit) + Position (II) (5 LEDs are lit)
= (Software Version 20) + (Software Version 5)
Note
As soon as any other key is pressed, processing returns to the machine program and the
corresponding function is performed.
Pos: 22 /BA/----- ---------- Seitenumbruch------ ---------- @ 0\mod_1 19617531122 6_0.docx @ 41 65@ @ 1