Krone Swadro 1000 - Install PTO Shaft; Rotating PTO Shaft Danger; Observe Drive Speed Danger

Start-up
51
Pos: 23.27 /Übersc hriften/Überschrif ten 2/F-J/G elenkwelle montier en @ 2\mo d_120239834 2788_78.docx @ 5 9253 @ 2 @ 1
7.5 Install the PTO shaft
Pos: 23.28 /BA/Sic herheit/Gele nkwelle/Gefahr - Sic h drehend eG elenkwelle_ 2@ 0\mod_1199 781692950_7 8.docx @ 3452 3 @ @ 1
Danger! - Rotating PTO shaft
Effect: Danger to life or serious injuries
• Install or detach the PTO shaft only with the engine switched off and the ignition key
removed.
• Secure the tractor against rolling.
• Make sure that the PTO shaft is coupled properly (the lock of the PTO shaft must have
snapped in).
• Make sure that the protective devices are attached properly.
• Never use a PTO shaft, the protective devices of which have not been attached.
• Replace damaged protective devices immediately
• Attach the safety chain of the PTO shaft so that the guard tube does not rotate
simultaneously with the PTO shaft.
Pos: 23.29 /BA/Sic herheit/Gele nkwelle/Gefahr - A ntriebsdrehza hl 540 beacht en @ 3\mod_120 5316518245_ 78.docx @ 73595 @ @ 1
Danger! - Observe drive speed
Effect: Danger to life or serious injuries
• This machine is driven at a maximum PTO speed of 540 rpm.
Pos: 23.30 /BA/I nbetriebnahme/ Schwader/Anba uG elenkwelle/A nbau Gelenkwelle angehängt e Schwader Bild @ 2\mod_1 20239807796 0_78.docx @ 5923 3@ @ 1
5
4
2
SW9070008
3
6
1
3
1
Figure 26
Pos: 23.31 /BA/I nbetriebnahme/ Schwader/Anba uG elenkwelle/A nbau Gelenkwelle angehängt e Schwader Te xt@ 37\mod_ 1263463772393_ 78.docx @ 3 39645 @ @ 1
• Switch off the engine and remove the ignition key.
• Install the PTO shaft (1) on the machine side (wide angle on machine side).
• Rotate the PTO shaft support (2) upwards.
• Then slide PTO shaft onto the PTO of the tractor. In doing this, ensure that the sliding pin
is securely engaged.
• Secure the PTO shaft guard against turning with the retaining chain (3).
Pos: 23.32 /BA/I nbetriebnahme/ Schwader/Maschi ne anheben U nterlenkeranh ängung @ 2\m od_1203505446 705_78.docx @ 66344 @ @ 1
Lifting the machine
• Lift machine slightly.
• Rotate the parking supports (4) 90° downwards and with the support (5) in this position
lock it and secure with spring cotter spring.
Pos: 24 /BA/----- ---------- Seitenumbruch------ ---------- @ 0\mod_1 19617531122 6_0.docx @ 41 65@ @ 1