Krone Swadro 1000 - Setting the Lifting Height in Headland Position

Settings
68
Pos: 34 /BA/Einstell ungen/Sch wader/Einstell end er Aushubhöh ein Vorgewend estellung SW 1 000 @ 137\m od_13535066730 40_78.docx @ 1218936 @ 2 @ 1
10.2 Setting the Lifting Height in Headland Position
SW1000024_2
Fig. 41
The lifting height of the rotors in headland position is determined by the position of the sensor
plate (1) on the respective outrigger arm.
The lifting height is set by adjusting the sensor plate (1).
To do this:
• Loosen the screws (2).
• Move the sensor plate in the oblong hole.
Moving sensor holder in "+" direction: The lifting height will be reduced.
Moving sensor holder in "-" direction: The lifting height will be increased.
Pos: 35 /BA/----- ---------- Seitenumbruch------ ---------- @ 0\mod_1 19617531122 6_0.docx @ 41 65@ @ 1