Maintenance
73
Pos: 42.14 /Übersc hriften/Überschrif ten 2/A-E/A nzugsdrehmom ente über In nensechskant @ 4 5\mod_12771 06415765_78.d ocx @ 411230 @ 2 @ 1
11.5 Tightening Torques (Countersunk Screws)
Pos: 42.15 /BA/ Wartung/Dreh momente / Anzugs momente/Dreh momente über In nensechska nt @ 45\mod_1 27710623232 8_78.docx @ 4112 05 @ @ 1
The tightening torque MA is stated in Nm
(unless otherwise indicated).
A = Thread size
(The stability class can be seen on the head of the
screw.)
Ø
5.6 8.8 10.9 12.9
MA (Nm)
M 4
2.5 3.5 4.1
M 5
4.7 7 8
M 6
8 12 15
M 8
20 29 35
M 10
23 39 58 67
M 12
34 68 100 116
M 14
108 160 188
M 16
168 248 292
M 20
340 488 568
A
BM 400 0234
NOTE
The table above applies only to countersunk screws with hexagonal socket heads and metric
threading that are tightened by the hexagonal socket head.
Pos: 42.16 /BA/ Wartung/Schwad er/Zinken / Zi nkenarme/Prüfen der Schraube n an den Zin ken @ 2\mod_1202 748503095_78. docx @ 612 40@ 2 @ 1
11.6 Testing the screws on the tines
SW700030
1
Figure 44:
The tine screws (1) must be retightened to the specified tightening torque after they have been
used the first time.
Pos: 42.17 /BA/--- ------ ------Seitenumbruch---- ------------ @ 0\m od_1196175311 226_0.docx @ 4 165 @ @ 1
To Next Page
Loading...
