Krone Swadro 1000 - Eliminating Alarm Messages

Medium Control Unit
44
Pos: 21.42 /BA/Inf o-Center/Schwader/Bedi eneinheit - Mediu m/Swadro 1000/Alarmmeldun gen beheben @ 2\mod_1203 325910168_78.docx @ 657 08 @ 2 @ 1
6.16 Eliminating Alarm Messages
If an error has been detected by the electronic system, it must be eliminated. If there is no more
alarm present after switching off and then switching back on again, that state will be indicated
by a continuous light on the
key (Symbol ON/ OFF).
Pos: 21.43 /Übersc hriften/Überschri ften 2/A-E/Anzeigen der Sof tware-Version @ 2\ mod_1203326630699_78.d ocx @ 65766 @ 2 @ 1
6.17 Displaying the Software Version
Pos: 21.44 /BA/Inf o-Center/Schwader/Bedi eneinheit - Mediu m/Swadro 1000/Anzeigen der Software-Version Bi ld @ 2\mod_120332668212 1_78.docx @ 65785 @ @ 1
SW1000034
(I)
(II)
Figure 21
Pos: 21.45 /BA/Inf o-Center/Schwader/Bedi eneinheit - Mediu m/Swadro 1000/Anzeigen der Software-Version Text @ 2\mod_12033260120 74_78.docx @ 65727 @ @ 1
To display the software version of the machine, press the key 10 times.
I ) Position (I) indicates the tens component of the software version.
For example, with software version 20, two LEDs are lit; with software version 40, four LEDs are
lit.
II ) Position (II) indicates the components of the software version.
For example, with software version 2, two LEDs are lit; with software version 5, five LEDs are lit.
Following is an example of software versions.
Software Version 25
= Position (I) (2 LEDs are lit) + Position (II) (5 LEDs are lit)
= (Software Version 20) + (Software Version 5)
Note
As soon as any other key is pressed, processing returns to the machine program and the
corresponding function is performed.
Pos: 22 /BA/----- ----------Sei tenumbruch-------- -------- @ 0\mod_1196175311 226_0.docx @ 4165 @ @ 1