Krone Swadro 1000 - Settings; Adjust Rotor Running Gear

Settings
67
Pos: 29 /Überschrif ten/Überschrif ten 1/A-E/Einstellunge n @ 0\mod_1199868783862_7 8.docx @ 36141 @ @ 1
10 Settings
Pos: 30.1 /Überschri ften/Überschri ften 2/K-O/Kreiselfahr werk einstellen @ 2\mod_120 2882031680_78.doc x @ 62105 @ 3 @ 1
10.1 To adjust the rotor running gear
Pos: 30.2 /BA/Einste llungen/Schwader/ Kreiselfahrwerk/K reiselfahrwerk Bil d Swadro 1000 8 Rad @ 22\mod_123986 4569081_78.doc x @ 234432 @ @ 1
SW1000040
1
2
Fig. 41
Pos: 30.3 /BA/Einste llungen/Schwader/ Kreiselfahrwerk/K reiselfahrwerk Text a llgemein SW 1000 @ 22\mod_123 9866403175_78.doc x @ 234457 @ @ 1
The transverse inclination (in direction of travel) and the longitudinal inclination (rotor tip
forwards) of the rotors can be changed by adjusting the front guide wheels of the right and left
running gear.
Pos: 30.4 /BA/Einste llungen/Schwader/ Kreiselfahrwerk/K reiselfahrwerk Quern eigung SW 1000 @ 22\mod_123 9866472456_78.doc x @ 234482 @ @ 1
Transverse inclination:
In order to achieve optimal operating results, the transverse inclination (in direction of travel) for
the right and left rotors can be adjusted individually at the front guide wheels of the relevant
running gear (left + right).
Pos: 30.5 /BA/Einste llungen/Schwader/ Kreiselfahrwerk/Q uerneigung Mittelsc hwad neu Swadro 1000 @ 22\mod_1 239866566269_78.d ocx @ 234507 @ @ 1
With centre swathing, the right guide wheel must be positioned lower than the left guide wheel
relative to the rotor running gear.
Pos: 30.6 /BA/Einste llungen/Schwader/ Kreiselfahrwerk/K reiselfahrwerk Längs neigung Swadro 1000 @ 22\ mod_1239866757316_78. docx @ 234532 @ @ 1
Longitudinal inclination:
A change in the longitudinal inclination (rotor tilts forwards) can be made by adjusting the height
of the front guide wheels (right and left) of the running gear.
Pos. I = Tilting decreased
Pos. II = Tilting increased
Pos: 30.7 /BA/Einste llungen/Schwader/ Kreiselfahrwerk/K reiselfahrwerk ein stellen vorgehens weise Swadro 1000 @ 22\mod_1239 866903144_78.doc x @ 234557 @ @ 1
Setting
• Remove cotter pin (1) and pull out bolt (2).
• Move the guide wheel into the desired position.
• Push in the bolt again and secure it with the cotter pin.
Pos: 31 /BA/----- ----------Sei tenumbruch-------- -------- @ 0\mod_1196175311 226_0.docx @ 4165 @ @ 1