Maintenance
72
Pos: 42.1 /Überschri ften/Überschri ften 1/U-Z/Wartung @ 0\ mod_1199883581050_78. docx @ 36685 @ @ 1
11 Maintenance
Pos: 42.2 /Überschri ften/Überschri ften 2/P-T/Spezielle Si cherheitshinweise @ 0\ mod_1196660495760_78. docx @ 9134 @ 2 @ 1
11.1 Special Safety Instructions
Pos: 42.3 /BA/Sic herheit/Gefahrenhin weise/Ladewagen/Gefahr Wartung allgemein @ 0\ mod_1199884069862_78. docx @ 36704 @ @ 1
Danger! - When performing repair, maintenance or cleaning work on the machine, or in
the case of technical intervention, drive elements may start moving.
Effect: Danger to life, injuries or damage to the machine.
• Switch off the tractor engine and remove the ignition key
• Secure the machine and tractor against the possibility of rolling back.
• Switch off the PTO and disengage it
• After the repair, maintenance and cleaning work or technical interventions are completed,
mount all protective coverings and safety devices properly again.
• Avoid skin contact with oils, greases, cleaning agents and solvents.
• In the event of injuries or burns due to oils, cleaning agents or solvents, contact a
physician immediately.
• All other safety instructions must also be followed to avoid injuries and accidents.
Pos: 42.4 /Überschri ften/Überschri ften 2/A-E/Entlastung sfeder(n) @ 2\mod_120350 8983876_78.doc x @ 66384 @ @ 1
11.2 Compensation Spring(s)
Pos: 42.5 /BA/Sic herheit/Gefahrenhin weise/Mähwerke/Gefahr - Einstellung an den Ent lastungsfedern @ 0\mod_ 1196751594562_78. docx @ 12575 @ 2 @ 1
Danger! - Setting on the compensation springs
Effect: Danger to life or serious injuries
• The compensation springs must only be removed in transport position. In the working
position the compensation springs are subject to high tensile stress.
• Severe injury can be caused if the compensation springs are removed while in the
working position.
• The lower threaded blocks on the compensation springs must be fully screwed in.
Pos: 42.6 /Überschri ften/Überschri ften 2/P-T/Probelauf @ 0\ mod_1196782963921_78. docx @ 14908 @ @ 1
11.3 Test run.
Pos: 42.7 /BA/Sic herheit/Gefahrenhin weise/Mähwerke/Gefahr - Verwendung von nic ht zugelassenen Ersatztei len @ 0\mod_11967830371 40_78.docx @ 14946 @ 2 @ 1
Danger! - Using non-approved spare parts.
Effect: Danger to life, serious injuries or loss of warranty claims as well as exclusion of liability
• Use only authentic KRONE spare parts and accessories authorised by the manufacturer.
The use of spare parts, accessories or additional equipment not manufactured, tested or
approved by KRONE will exclude any liability for consequential damage.
Pos: 42.8 /BA/War tung/Hinweis Verschleiß verringern @ 0\mod_1199 953505303_78.docx @ 37204 @ @ 1
Note
To ensure problem-free operation of the machine and to reduce wear and tear, specific
maintenance and upkeep intervals must be observed. These include cleaning, greasing,
lubricating and oiling parts and components.
Pos: 42.9 /BA/--- ------------ Seitenumbruch---------------- @ 0\mod_1196175311226_0.docx @ 4165 @ 2 @ 1
To Next Page
Loading...
