Maintenance
74
Pos: 42.14 /Übersc hriften/Überschri ften 2/A-E/Anzugsdreh momente über Innensechsk ant @ 45\mod_1277106415 765_78.docx @ 411230 @ 2 @ 1
11.5 Tightening Torques (Countersunk Screws)
Pos: 42.15 /BA/W artung/Drehmomente / Anzugsm omente/Drehmomente üb er Innensechskant @ 45\ mod_1277106232328_78. docx @ 411205 @ @ 1
The tightening torque MA is stated in Nm
(unless otherwise indicated).
A = Thread size
(The stability class can be seen on the head of the
screw.)
Ø
5.6 8.8 10.9 12.9
MA (Nm)
M 4
2.5 3.5 4.1
M 5
4.7 7 8
M 6
8 12 15
M 8
20 29 35
M 10
23 39 58 67
M 12
34 68 100 116
M 14
108 160 188
M 16
168 248 292
M 20
340 488 568
A
BM 400 0234
NOTE
The table above applies only to countersunk screws with hexagonal socket heads and metric
threading that are tightened by the hexagonal socket head.
Pos: 42.16 /BA/W artung/Schwader/Zinken / Zinkenarme/Prüfen der Schrauben an den Zinken @ 2\mod_12 02748503095_78.doc x @ 61240 @ 3 @ 1
11.6 Testing the screws on the tines
SW700030
1
Figure 46:
The tine screws (1) must be retightened to the specified tightening torque after they have been
used the first time.
Pos: 42.17 /BA/--- ------------ Seitenumbruch------ ---------- @ 0\mod_119617 5311226_0.doc x @ 4165 @ @ 1
To Next Page
Loading...
