Krone Swadro 700 - Function of the Switches on the Control Unit (Optional)

III - 5
Preparing for Operation
The control unit can be used to preselect or control
several functions of the swather. Please observe the
following basic rules:
Always activate one function only on
the control unit.
The switches of all other functionss
must be set to neutral.
The control unit should be switched off
after any use to prevent functions being
activated inadvertently.
The following table shows the function of the different
switches.
3.3.7 Function of the switches on the
control unit (optional)
Item Designation Function
1 Main Switches the control unit
switch on and off
2 Indicator light Lights up when the control
(green) unit is switched on
3 Rocker switch
Raises or lowers the left hand
(touch-sensitive) rotor (when seen in the
travail direction)
4 Rocker switch
Raises or lowers the right
(touch-sensitive) hand rotor (when seen in
the travail direction)
5 Rocker switch Preselects the rotor carrier
arm which hat to be raised
or lowered.
The actual function can be
performed using the tractor
hydraulics.
SW700005
4
3
2
1
5