Krone Swadro 800/26 - Folding Tine Arms into Working Position

IV - 3
Handling the swather when in use
The rotor arms can be switched from
transport to working position without
the electric control being switched on.
In this case both rotor arms are always
actuated simultaneously.
SW700008
2
1
Fold the tine arms from transport to working position.
• To release the rotor locking device, detach tension
spring (1) from tine securing clamp (2) and attach
to hole (3)
• Move rotors from transport to working position (see
section „Conversion from transport to working
position“).
• Remove linch pin (1).
• Pull out pin (2).
• Fold tine arms (3) into working position. It may be
necessary to turn the rotor until, when folding tine
arms, they do not collide with the guard.
• Insert pin (2) and secure with linch pin (1).
4.3.4 Folding the tine arms into working
position
During work operation, leave the
control valve in „Lower“ position.
• Operate single acting control valve on the tractor and
apply pressure to the hydraulic cylinders. This will
release the lock (1).
• Unlock the lock (1) by pulling the actuating cable (2).
Keep cable under tension.
• Use the control valve to slowly lower the outer rotor
until the wheels are on the ground.
• Release the actuating cable (2).
3
2
1
2
1
SW700010
Pin (2) must always be inserted from the
top with the respective tine arm in the
front part of the rotor (tines must touch
the ground).
SW700036
1
2
3
3
1
Shut down the engine and remove the
ignition key. Secure tractor and rotary
swather against rolling away!