IV - 5
Handling the swather when in use
Remove pin (1) for securing external guard bar (2) and
fold up guard bar. Reinsert pin at the hinge point of the
guard bar.
4.5 Conversion from working to
transport position
• Before raising the swather disk above
the working position, turn off the PTO
shaft and wait until the swather disks
comes to a stand still.
• Ensure that nobody is within the
folding range of the rotors.
4.5.1 Moving the external guard bars into
transport position
SW700011
1
2
Do not touch the guard bars near the
hinge points. Danger of bruising!
Before switching to transport position,
move in the width adjustment (see
section „Setting the working width“).
To Next Page
Loading...
