IV - 7
Handling the swather when in use
Electrical operation device
• Switch on operation device (0 > 1)
• Move switch (6) to the central position
• Disengage the lock via the actuating cable and set
the tractor hydraulics actuation lever to „Lift“.
• Keep pulling the actuating cable until the pin on the
swather arm has gone past the engagement point for
the working position. Raise the swather arms until the
lock has snapped into the transport position.
4.5.3 Lifting the rotor arms – mechanically
Make sure that the transport position
snaps in correctly and that the
actuating cable is not under tension.
SW700013
1
4.5.5 Lifting the rotor arms – electrically
(optional)
• Disengage the lock via the actuating cable and set
the tractor hydraulics actuation lever to „Lift“.
• Keep pulling the actuating cable until the pin on the
swather arm has gone past the engagement point for
the working position. Raise the swather arms until the
lock has snapped into the transport position.
Make sure that the transport position
snaps in correctly and that the
actuating cable is not under tension.
SW700013
1
SW700005
4
3
2
1
5
4.5.4 Lifting the rotor arms – hydraulic
single-rotor lifting system
KS568001
1
• Move switch cock into the central position.
• Disengage the lock via the actuating cable and set
the tractor hydraulics actuation lever to "Lift".
• Keep pulling the actuating cable until the pin on the
swather arm has gone past the engagement point for
the working position. Raise the swather arms until the
lock has snapped into the working position.
To Next Page
Loading...
