VI - 2
Care and maintenance
1
KS-0-034
6
2
3
4
5
6.3 Tyres
• Installing wheels and tyres requires sufficient knowledge and the availability of proper tools!
• Repair work on the tyres and wheels may only be carried out by specialists using appropriate
tools!
• Set down rotary swather on firm, even ground. Prevent unintended rolling away with wedges.
• Regularly check that wheel nuts are properly seated and tighten if necessary!
• Regularly check air pressure!
Check the tyre pressure at regular intervals (100 h) and
refill if necessary. The values can be found in the
adjacent table.
6.3.2 Wheel fixings
6.3.1 Air pressure
Regularly (50 h) check that wheel nuts are properly
seated and tighten if necessary! The sequence in the
graphic opposite should be observed.
Swadro 700 Tyres Tyre pressure
Swadro 800 [bar]
Swadro 900
Single-axle 18 x 8.50 6 PR 1
Tridem-axle 16 x 6.50-8.4 PR 1
Main chassis 10.0/75-15.3 8 PR 1
The tine screws (1) must be retightened to the specified
tightening torque after they have been used for the first
time.
SW700030
1
To Next Page
Loading...
