Krone Swadro TC 640 - Lowering Outrigger Arms into Working Position

Operation
56
9.2 Removing the tine protections from the tine tips
TC640-010
3
2
1
1
Fig.
24
• Switch off tractor and secure it against rolling away.
• Remove the tine guards (1) from the machine.
• Insert the tine guards into the support (2) and secure them with linch pins (3).
• Repeat this process for the other side of the machine.
9.3 Lowering Outrigger Arms into Working Position
• Shut down and safeguard the machine, see chapter Safety -> Safety routines, "Shutting
down and safeguarding the machine".
2
1
SW700065
Fig.
25
• Switch on the tractor.
• To relieve the locks (1), actuate the single-action control unit at the tractor and pressurise
the hydraulic cylinders.
• To release the locks (1), pull the actuating rope (2) and keep it tensioned.
• Set the single-action control unit (red 1+) of the tractor to the float position.
• When the rotors are in the working position, release the actuating rope (2).
• Switch off the tractor and secure it against the possibility of rolling back.