Krone Swadro TC 640 - For Design with Collapsible Tine Arm

Operation
58
9.4.2 For design with collapsible tine arm
Fig.
27
NOTICE! Swivel folding tine arms into working position in a certain order:
- In direction of travel right, swivel the folding tine arms into working position starting from the
rear.
- In direction of travel left, swivel the folding tine arms into working position starting from the
front.
• Pull the linch pin (1).
• Pull out the bolt (2).
CAUTION! When swivelling the tine arms into working position, turn the rotors so that the tine
arms do not collide with the guard.
• Swivel the tine arm (3) into working position.
NOTICE! The bolts may collide with the rotor axle if they are not inserted from above and
secured.
• Insert the bolt (2) from above.
• Secure the bolt with the linch pin (1).
Make sure that the linch pin (1) engages properly (the ring of the linch pin must be in the groove
of the shaft).
2
3
2
3
1
1
SW9070017_1