Krone Swadro TC 640 - For Design with Collapsible Tine Arm

Operation
63
9.9.2 For design with collapsible tine arm
SW9070080_1
2
3
2
3
1
1
Fig.
31
First:
• Turn the left rotor until the folding tine arms are extended outwards.
• Pull the linch pin (1).
• Pull out the bolt (2).
• Swivel the tine arms (3) into the transport position; it may be necessary to turn the rotor to
prevent the swivelling tine arms (3) from colliding with the guard.
• Insert the bolt (2) and secure with the linch pin (1).
Then:
• Turn the right rotor in the working direction until the folding tine arms are also extended
outwards.
• Pull the linch pin (1).
• Pull out the bolts (2).
• Swivel the tine arms (3) into the transport position; it may be necessary to turn the rotor to
prevent the swivelling tine arms (3) from colliding with the guard.
• Insert the bolt (2) and secure with the linch pin (1).
Notice
Check whether the folding tine arms (3) on both rotors are extended outwards. If required,
move the rotors into the correct position.
Notice
Swivel the right folding tine arms on the machine side from the front to the rear and the left
folding tine arms on the machine side from the rear to the front into the transport position.