Krone Swadro TC 880 - Tine Arm to Lifting Cylinder Distance

Commissioning
46
8.9 Checking / Setting the Distance Between Tine Arm and Lifting Cylinder
CAUTION!
The machine may be damaged if the dimension X1 is not set.
• Check dimension X1 and set it, if necessary.
27 016 473 0
1
2
Fig. 15
4
TC880-001
5
3
1
2
Fig.16
Prerequisite:
– The machine is in headland position and the outrigger arms are completely retracted.
• In order to achieve the shortest possible distance between tine arm and lifting cylinder,
press tine arm towards outrigger arm.
• Measure the distance X1 between tine arm (1) and outrigger arm (2).
If the dimension is X1 ≥ 100 mm, everything is OK.
If the dimension is not X1 ≥ 100 mm, the distance must be set via intermediate link.
• Dismount bolt (4).
• Loosen counter nut (5).
• Turn the intermediate link (3) until the dimension X1 ≥ 100 mm is set.
• Tighten counter nut (5).
• Mount bolt (4).