Driving and Transport
58
10.1 Preparations for road travel
SW9000009
2
1
Fig. 26
Before road travel, make sure that
• the machine is fully and correctly hitched.
• the PTO shaft is switched off and the rotors have come to a standstill.
• the rotors are locked (right and left sides of the machine).
• the machine is in transport position.
• the rotor arms are retracted to the stop (the indicator arrow (1) is located just before the
second screw).
• the control unit is switched off; on machines with electric single-rotor lifting mechanism.
• all hydraulic control units are in neutral position.
• the tines guards (2) are plugged onto the tines which are located in the transport position
below 2 m (right and left sides of the machine).
• the lighting system functions properly.
• the lower links are set to a height of 660 mm to the ground in order to observe the transport
height.
To Next Page
Loading...
