Operation
69
11.7 Adjusting the Working Width
• Shut down and safeguard the machine, see chapter Safety -> Safety routines, "Shutting
down and safeguarding the machine".
Caution! - Adjusting the working width
Effect: Damage to the machine
• Before extending the rotors, make certain there is no one in the danger zone of the rotors!
• Never try to adjust the working width if the tractor is switched off and the tines are in contact
with the ground.
• Only set the working width of the rotor arms in headland position.
• In order to lift the rotors to the headland position, actuate the single-action control unit
(red 1+).
• In order to increase the working width, actuate the double-action control unit (blue 2+).
• In order to reduce the working width, actuate the double-action control unit (blue 2-).
• CAUTION! In order to meet the transport height, retract rotors completely.
The distance between the rotors and the swath former:
high amount of forage = long distance
small amount of forage = short distance
To Next Page
Loading...
