Kronos Timekeeper 400 Series - Page 5

Contents
Series 400 Terminal Maintenance and Troubleshooting Guide v
Token Ring Troubleshooting .............................................................4-19
Chapter 5: Changing Terminal Firmware
Using the Correct Versions ........................................................................5-2
About the Flash Utility .........................................................................5-2
About the Boot-EPROM ......................................................................5-2
About the Flash Application Program .................................................5-3
Softloading an Application with SL400 .....................................................5-4
SL400 for Windows .............................................................................5-4
SL400 for DOS ....................................................................................5-7
Chapter 6: Using Maintenance Mode
Command Modes Overview .......................................................................6-2
Operating in Maintenance Mode ................................................................6-3
Maintenance Mode Password .....................................................................6-4
Commands List ...........................................................................................6-5
Executing Commands .................................................................................6-8
Appendix A: Error and Status Messages
Interpreting Error Messages ......................................................................A-2
Error Messages .........................................................................................A-3
Status Messages .......................................................................................A-18
Appendix B: Series 400 Terminal Part Numbers
Part Numbers ............................................................................................. B-2
Index