To Next Page

To Previous Page

Features of Programmable Timer Models

If your model has a programmable clock/timer the following features are included:

. Auto On - Allows you to set the daily start time of the brew cycle.

Auto Off - Allows you to set the length of time the coffee machine will stay on. It can be set

from 1 to 5 hours for units with glass carafes and is set to 20 minutes for units with thermal

carafes.

Audible Signal - Beeps when the coffee is done brewing. This can be turned off or on.

. 1 - 3 Cup Flavor Setting : To extract the full flavor or the grinds from smaller quantities. (10)

Exercise caution with hot water and steam.

Electronic Limescale Detection - Indicates when the coffee machine needs to be descaled.

Empty Water Reservoir - Indicates when the water reservoir has not been filled and

automatically shuts off the coffee machine.

Programming Your Coffee Machine

• Plug in your appliance: the display will light up briefly in blue, blink “8888“ and then remain

fixed.

• Press the O/I button if you wish to make coffee without using the programmable mode.

• The display will light up in blue and alternately show “ON“ and the current time.

• Press the O/I button to shut off the coffee machine. The display will no longer be lit.

Setting and Adjusting the Clock

• The machine must be “off“.

• Press and hold the prog button (o) for 3 seconds: the hours will blink “88 _ _“.

• Adjust the hours in steps by pressing the h/min button (n).

• Press the prog button : the minutes will blink“ XX 88“.

• Adjust the minutes in steps by pressing the h/min button.

• Confirm the setting by pressing the prog button.

Setting Auto On

This programs the coffee machine to start automatically at the set time each day.

• Press the prog button (o) briefly : the display will blink “prog“ for about 1 second, followed

by “8888“.

• Press the prog button briefly: the hours will blink “88 _ _“.

• Adjust the hours in steps by pressing the h/min button (n).

• Press the prog button briefly: the minutes will blink “XX 88“.

• Adjust the minutes in steps by pressing the h/min button .

• Confirm the setting by pressing the prog button briefly:

prog

1-3

h/min

NPA USA. PM6.5 copie 4/12/06, 10:269

Krups FME214 User Manual

Questions and Answers: