. Removethe "Perfect
Froth"attachment from
the steam nozzle and
clean it in warm, soapy
water. Use caution when
removing the "Perfect
Froth" from the steaming
nozzle as it may still be
hot.
. Cleanthesteamnozzle
with a damp cloth. Use
caution wI;en cleaning
the steaming nozzle, the
nozzle may still be hot.
Exercise
Caution When
Using The Steaming
Nozzle; It Is Very Hot!
Cleaning',
. Werecommend
washing the capsule
holder in the dish-
washeronce aweek.
. Afteruse,emptythe
waterreservoiranddrip
tray.
. Afterusing yourKRUPS
"NespressoSystem"
approximatelytentimes,
thedrip tray willneedto
be emptiedandcleaned.
. Thewater reservoir,drip
tray,grid, capsule
holder,PerfectFroth
attachmentshouldbe
washedand rinsedin
warm,soapy wateron a
regularbasis.
. Werecommendwashing
thewaterreservoirinthe
dishwasheroncea week.
Thiswilleliminateany
12
"":.:'7~~"':":~i1f;;~.~'
mineraldeposits from
building.
. Beforereplacing the drip
tray and grid, make sure
that the baffle has been
placed in the back of the
drip tray (flg.18).
. Clean the steam/hot
water nozzle immediately
after frothing milkwith a
damp cloth.
. If the nozzle becomes
clogged for any reason,
remove the screw
holding the steam nozzle
in position (flg.19) and
remove all milk particles
(use a needle and rinse
under faucet).
. Replace steam nozzle
and be sure screw is
turned tightly.
Do not
place any of the
loose pieces Into the
dishwasher.
IMPORTANT
Clean the steam nozzle
each time after you have
immersed it in milk, other-
wise the inside of the
nozzle becomes clogged
and difficult to remove.
Allow the steam to escape
into a wet cloth for one or
two seconds.
Any milk residue will be
flushed out. See special
cleaning instructions for
"Perfect Froth".
'~~""'"
.."
Caution:
Do not try to disassemble
the mainbody of the
machine.
If youwish to prepare
espressoimmediatelyafter
usingthe steamoperation,
the machinemustcool
downto the proper
temperature.Toaccelerate
this process insertthe
capsule holder intothe
machinewithouta capsule,
and runwaterthroughthe
machineuntilthe yellow
light turn off.
Decalcifying
,
Under normalconditions
you do not need to
decalcify your machine.
However,in areaswhere
there is hard water or if
used very frequently we
recommend decalcifying.
Youwill knowwhen such a
cleaning
is necessary by
an obvious slow down in
the brewing time of your
coffee. Pleasecontact
Nespresso House for
further information
Cleaning The
Capsule Cage
1.Periodically, the capsule
cage should be
thoroughly cleaned.
Turn "OFF" the machine
and plug. Remove the
water reservoir and drip
tray with grid (fig.21).
.. :.:.}:\':~:?"~"1~;:2;r'
2.Turn machine upside
down (fI9.22) place the
capsule cage key on the
capsule holder (flg.23).
3.To unscrew the capsule
cage, turn the capsule
cage key countp.r
clockwise (fig.24-26).
Caution:
When replacing capsule
cage do not overtighten.
4.Take the capsule housing
out of the removal device
and remove "0" ring from
capsule housing (fig.26).
Rinse housing and "0"
ring under faucet to
r.gmove any loose
particles.
S.Clean the two holes in the
shaft of the capsule
housing using the clea-
ning needle instrument
(m) (flg.27 and 28). Then
blewing to remove any
dirt.
Place "0" ring back on
capsule housing.
6.To reinsert capsule
housing, place the
capsule housing back
into the capsule housing
removal device (n).
Turn the machine to the
right position.
Insertthe capsule housing
removal device back into
the machine by turning it
clockwise by hand, making
sure it is tight (flg.29)
(do not overtighten).
The capsule holder is not
required to reinsert capsule
housing back into the
machine.
7f"'-::~T"~1~'-~~ ':-'.' . '..
. ""
Problems And
Solutions
Problem:
Coffee temperature too low.
Solution:
. Place the cups on the
warming plate of the
appliance to preheat.
. Leave the empty capsule
holder in the machine.
Problem:
Loud pump noise.
Solution:
. Checkto make sure the
water reservoirhas been
filled and inserted
correctly.
Problem:
Not enough frothwhen
frothing milk.
Solution:
. Steamnozzle or Perfect
Froth clogged.
. Old milk, or previously
heated milk.
Problem:
Coffeedoes not flow out.
Solution:
. Make sure water
reservoiris properly
filled.
. Check whether the water
reservoirhas been
properly inserted.
. Themachinemayneed
to be decalcified (see
section "Decalcifying").
':,:!3>
. Capsule housing needs'
to be cleaned (see
section "Cleaning the
capsule cage").
If machine still does not
function properly, or if
you have further
questions or concems,
please direct your
inquiries to the
Nespresso House at
1-800-562-1465
To Next Page
Loading...
Need help?
General
