Krups XP1600 User Manual

Putting in the ground coffee
1. Swing out the lter holder (6) and insert a paper lter in the lter basket. We recommend
using size #4 paper lters. When inserting a paper lter make sure the seam is pointing
toward the base of the lter holder (7).
Use your hands to conform the lter to the contours of the lter basket. This will allow you
to achieve better results.
2. Put ground coffee into the lter basket (8). We suggest using one KRUPS measuring
spoon of ground coffee for each cup of robust brewed coffee. You can adjust the quantity
to suit your own taste.
We do not recommend using coffee that is ground to a powder-like consistency, as this
will prevent water from passing through the lter.
3.Close the lter and make sure that it is completely closed (9).
!
ATTENTION :
Make sure that the lter paper does not fold over when closing the swivel lter,
otherwise the water might run between the lter paper and the lter holder producing
a very weak cup of coffee.
Filling the Water Chamber
1. Open the hinged lid (10). Pour in the desired quantity of water (11) and close the lid. The
amount of freshly brewed coffee delivered after the brewing process will always be slightly
less than the amount put into the water chamber. This is due to the minimal absorption
of the water by the ground coffee. The water levels on the carafe and appliance take this
absorption into account for more convenience.
2. Place the glass carafe with lid in position on the warming plate.
3. Push the “coffee” button to turn on the coffee side of the appliance. The indicator light
will illuminate indicating that the brewing process has begun.
4. As long as the blue indicator light is illuminated the coffee will be kept warm.
Pause and Serve Feature
The Pause and Serve feature automatically stops the ow of brewed coffee through the
lter cone if the glass carafe is removed from the warming plate during the brewing cycle.
You have about 20 seconds between the removal of the carafe and it being reinserted back
onto the warming plate.
The Pause and Serve device closes off the lter cone so effectively that there is virtually no
coffee dripping onto the warming plate. Once the carafe is replaced, the brewing process
and the ow of coffee into the carafe will resume.
!
CAUTION
If signicant amounts of coffee drip onto the warming plate after the carafe has been
removed, please check the seal in the lter holder to ensure it is placed properly. If
a requirement seal is needed, please contact one of our main service centers or our
main parts center.
If the lter is overlled with coffee grounds, it could cause the water that jets into the lter
cone to overow between the lter and the sides of the lter cone. Be sure to use the proper
amount of ground coffee.
If blockage and subsequent dripping does occur, put the glass carafe immediately back
onto the warming plate, and allow the full brewing cycle to run its course. Do not swing out
the swivel lter until the brewing process is completed.
10

Krups XP1600 Specifications

General

Brand	Krups
Model	XP1600
Category	Coffee Maker
Language	English