31
PROBLEMS POSSIBLE CAUSES SOLUTIONS
The appliance doesn't
work.
The pump has been
deactivated due to a lack
of water.
Fill the tank with water
and re-initiate the pump
(see paragraph: USING
FOR THE FIRST TIME).
Avoid emptying the tank
completely.
The removable water tank
has been tted incorrectly.
Position the water tank
correctly.
The super cappuccino
nozzle produces little or no
froth.
The super cappuccino
nozzle is not properly
installed.
Check that the accessory
has been properly
mounted on the appliance:
remove it and then install it
again on the swivel arm by
means of a rm twist from
right to left.
Check that the exible
hose is not obstructed
or twisted and that is ts
properly into the accessory
to prevent any air intake.
The milk is too warm. Use a small jug. Use very
fresh, very cold milk.
Follow the milk frothing
instructions (paragraph on
STEAM FUNCTION).
The super cappuccino
nozzle does not suck up
any milk.
Rinse and clean the
accessory (please refer to
the chapter on «Maintenance
and Cleaning»).
If it is not possible to identify the cause of a malfunction, please contact an approved
service centre. Never disassemble the appliance. (if the appliance has been
disassembled, the guarantee may no longer be valid).
We participate in the protection of the environment!
Your appliance contains a number of materials that can be reused or recycled.
Take it to a collection point or an approved service centre so that it can be dealt
with appropriately.
ELECTRIC OR ELECTRONIC PRODUCT AT END
OF LIFE
To Next Page
Loading...
