6 7
Instructions for use
Charging the battery
The Clash Evo has a built-in rechargeable lithium battery. Make sure the Clash Evo
is switched off. Connect one end of the micro USB charge cable to the micro USB
charge port (4) on the Clash Evo and connect the other end to your PC or USB
mains adaptor. The battery will start charging.
• It takes up to 4 hours to fully charge the battery
• Whilst charging, the LED indicator (7) will be solid red
• When fully charged, the LED indicator (7) will turn off
Getting started
– To turn the Clash Evo on, press and hold the MFB (1) for 4 seconds
– To turn the Clash Evo off, press and hold the MFB (1) for 4 seconds
whilst they are on
LED status
LED indicator is: Clash Evo is:
Solid red charging
Off fully charged/switched off/aux mode
Flashing blue quickly in pairing mode
Solid blue connected in Bluetooth mode
Slowly ashing blue playing in Bluetooth mode
Bluetooth setup
Pairing a Bluetooth device for the rst time
With the Clash Evo turned off
1. Press and hold the MFB (1) for 4 seconds
2. The LED indicator (7) will ash blue quickly
3. Activate the Bluetooth feature on your device and search for Bluetooth devices
(check your device’s manual if you’re unsure how to do this)
4. Select ‘KSCLASHEVO’ from the list of found devices
5. If asked for a passcode, enter ‘0000’ and the Clash Evo will then be connected
to your device
6. After pairing successfully, the LED indicator (7) will turn solid blue
7. The next time the Clash Evo is switched on, it will automatically search for and
attempt to connect to the last paired device
Note: If your device is not connecting automatically, it’s because it is not the last
paired device. Simply delete ‘KSCLASHEVO’ from the list of Bluetooth devices on
your device and re-pair.
To Next Page
Loading...