BATTERY REMOVAL INSTRUCTIONS
(FOR DISPOSAL AND RECYCLING)
Battery must not be removed by the consumer.
At the end of product life, only an authorized
recycler may safely remove battery by using the
following steps.
Model S-MONO-V11
Step 1: The device should be fully discharged
before disassembling it.
Step 2:
Detach the lower plate at the bottom side
with a tool, and then remove the
adhesive tape.
Step 3: Remove 2 screws.
Step 4:
Disassemble the housing from the internal
components.
Step 5: Remove all screws and detach Frame
Parts.
Step 6:
Remove rubber and disconnect 2 connec tors,
then detach PCB from the device body.
Step 7: Remove the battery and dispose of it
according to local regulations.
Confirmation of Compliance
Caution
Only use this device with tobacco sticks
designed for lil SOLID.
Tobacco sticks are sold separately.
This device must not be sold to minors.
lil, lil SOLID, lil SOLID Ez are trademarks owned
by KT&G Corporation and
used under license
by Philip Morris Products S.A.
IQOS is a trademark owned by Philip Morris
Products S.A.
To Previous Page
Loading...