48
Cleaning with heat
Quickly press the Button
5 times (within 2 seconds).
The Status LED blinks in
orange, for 90 seconds,
and the cleaning
process proceeds
automatically.
When the cleaning
process ends, the Status
LED automatically
goes off, and vibration
occurs 2 times.
* Cleaning with heat means heating the remnants
stuck to the heater. The heater can get very hot,
so do not let anything come into contact with
the heater during or immediately after cleaning
with heat.
6. Troubleshooting
I cannot insert the stick into the device.
Check for any remnants
inside the stick insertion
part. If there are remnants
of a used stick, remove
the Cap from the device.
Remove the remnants
from the Cap.
If there are remnants from the previous stick inside
the stick insertion part, a stick may not be inserted.
Remove the remnants by pulling the Cap out of the
device and try to insert the stick again.
To Next Page
Loading...