Important Safety Precautions
I.Please read all the instructions carefully before using the product.
2.When cleaning the display, please unplug the power cord. Please wipe the display with
a soft wet cloth instead of liquid or spray cleaner. Please use LCD screen cleaner in case
of a stubborn stain.
3.00 not use accessories that ore not recommended by the manufacturer, or there may
be dangerous.
4.When unplugging the power cord of the display or the power adapter, please hold the
power plug with your hand rother than directly pull the power cord to unplug it.
5.00 not ploce the display near water, such as bathtub, washbasin, kitchen sink, or
washing machine. Do not place the display on the wet ground, or near the swimming
pool. Do not use fingers or hard objects to press the surface of the LCD screen.
6.The grooves and holes on the shell or ot the bock and bottom of the display are
designed for the ventilation and heat dissipation of the components to ensure reliable
operation. So, do not put the display on the bed, sofa, carpet, or other similar surfaces
to prevent the heat dissipation holes from blocking and do not place the display near or
above the radiator or heater. In addition, do not ploce the display in an embedded device
unless adequate ventilation is provided.
7.0nly the power supply type shown on the nameplate can be used for the display.
Please feel free to consult the display dealer or the local power supply administration, if
you have any doubts about your power supply type.
8For safety, the display or the power adopter uses a power cord with o three-prong plug,
whose third prong can only be properly grounded when used with a properly grounded
socket. If your socket cannot match with the plug, please contact an electrician to
replace your original socket so that the plug con give full play to ensuring safety.
9.As you may face high voltage or other dangers after removing the shell, do not repair
the display by yourself. You can have it repaired by qualified maintenance personnel.
10.Pleose unplug the power cord of the display or the power adopter from the socket,
and contact qualified maintenance personnel for repairing the display, when following
cases occur:
o.The power cord or the plug is damaged or worn out.
b.The display hos been dropped from high or the shell is damaged.
c.Any obvious abnormality indicates a necessary repair.
11.Please place the display in o well-ventilated environment, which is away from strong
light, high temperature, or humidity.
12.The room temperature for the display store is -100C—600C, or it may be permanently
damaged.
To Next Page
Loading...