KTM 125 SX EU 2015 - Installing the Air Filter Box Lid; Removing the Air Filter; Cleaning the Air Filter and Air Filter Box

11 SERVICE WORK ON THE CHASSIS 49
11.23 Installing the air filter box lid
B02101-12
–
Insert the air filter box lid into rear area

and clip it into front area

.
B02101-10
Condition
The air filter box lid is secured.
–
Mount and tighten screws

.
Guideline
Screw, air filter box lid EJOT PT
®
K60x20-Z
3 Nm
(2.2 lbf ft)
EJOT PT screw
(0017060204)
11.24 Removing the air filter x
Note
Engine failure Unfiltered intake air has a negative effect on the service life of the engine.
– Never operate the vehicle without an air filter as dust and dirt will enter the engine and lead to increased wear.
Warning
Environmental hazard Hazardous substances cause environmental damage.
– Oil, grease, filters, fuel, cleaners, brake fluid, etc., should be disposed of as stipulated in applicable regulations.
Preparatory work
– Remove the air filter box lid. ( p. 48)
B02102-10
Main work
–
Detach air filter holder

at the bottom and swing it to one side. Remove the air
filter with the air filter support.
– Remove the air filter from the air filter support.
11.25 Cleaning the air filter and air filter box x
Warning
Environmental hazard Hazardous substances cause environmental damage.
– Oil, grease, filters, fuel, cleaners, brake fluid, etc., should be disposed of as stipulated in applicable regulations.
Info
Do not clean the air filter with fuel or petroleum since these substances attack the foam.
Preparatory work
– Remove the air filter box lid. ( p. 48)
–
Remove the air filter. x ( p. 49)