KTM 125 XC-W EU 2017 - 3.16 Installing the headlight mask with the headlight; 3.17 Checking the headlight setting

3 WORK 25
3.16 Installing the headlight mask with the headlight
E00356-11
Main work
(All EXC/EXC Six Days models)
–
Connect plug-in connectors

.
E00357-11
(All XC‑W/XC‑W Six Days models)
–
Connect plug-in connector

.
E00355-11
–
Position the headlight mask and fix it with rubber bands

.
The holding lugs engage in the fender.
– Position the brake line and wiring harness in the brake line guide.
Finishing work
– Check the headlight setting. ( p. 25)
3.17 Checking the headlight setting
400726-10
– Position the vehicle upright on a horizontal surface in front of a light wall and make
a mark at the height of the center of the low beam headlight.
–
Make another mark at a distance

under the first mark.
Guideline
Distance

5 cm (2 in)
–
Position the vehicle vertically a distance

away from the wall.
Guideline
Distance

5 m (16 ft)
– The rider now sits down on the motorcycle.
– Switch on the low beam.
– Check the headlight setting.
The boundary between light and dark must be exactly on the lower mark for a
motorcycle with rider.
» If the light-dark border does not meet specifications:
– Adjust the headlight range. ( p. 26)