Adjusting oil pump (only with separate lubrication)
NOTE: Prior to adjusting the oil pump, you have to check and, if
necessary, adjust the clearance of the throttle cable.
– Loosen the 3 bolts
1 of the oil pump housing and remove the oil
pump cover
2. To make adjustment and control easier, loosen the
bolts of the intake flange
3, remove 4 of them and move the flange
sidewards.
– If the oil pump has been adjusted correctly, the mark
A must coincide
with the notch
B on the cable pulley (except 125 EXE and 125
Supermoto).
– On 125 EXE- and 125 Supermoto-models the notch
B must coincide
with the edge C.
!
CAUTION
!
IF THE ADJUSTMENT OF THE OIL PUMP IS NOT CORRECT, THE ENGINE IS NOT SUPLIED
WITH THE CORRECT AMOUNT OF OIL AND THIS CAN RESULT IN ENGINE DAMAGE
.
– If necessary, loosen the lock nut
4, and correct the adjustment by
turning the adjusting screw
5 as required.
– Following the adjustment procedure, the lock nut has to be tightened
again.
–Mount cover
2 and flange 3, tighten the 2 bolts.
2-5C
4
5
1
2
3
A
B
B
C
To Next Page
Loading...
