13 SERVICE WORK ON THE CHASSIS
228
Info
When a new chain is mounted, the rear sprocket
and the engine sprocket should also be
changed.
New chains wear out faster on an old, worn rear
sprocket or engine sprocket.
For safety reasons, the chain has no chain joint.
S04102-01
– Check the chain sliding guard for wear.
» If the chain sliding guard shows a lot of wear:
– Change the chain sliding guard.
– Check that the chain sliding guard is firmly seated.
» If the chain sliding guard is loose:
– Tighten screws on the chain sliding guard.
Guideline
Screw, chain slid-
ing guard
M5 5 Nm (3.7 lbf ft)
To Next Page
Loading...
