SERVICE WORK ON THE CHASSIS 13
229
S04103-01
– Check the chain sliding piece for wear.
» If the lower edge of the chain is in line with or below the
chain sliding piece:
– Change the chain sliding piece.
– Check that the chain sliding piece is firmly seated.
» If the chain sliding piece is loose:
– Tighten screw on the chain sliding piece.
Guideline
Remaining screws,
chassis
M8 25 Nm
(18.4 lbf ft)
Finishing work
– Remove the rear of the motorcycle from the lifting gear.
( p. 199)
To Next Page
Loading...
