BRAKE SYSTEM 14
245
S03925-10
Main work
– Position the vehicle upright.
–
Remove screw
1
with the screw cap lock.
Info
Make sure that the reservoir stays vertical and no brake
fluid runs out.
–
Remove screw cap
2
with the washer and membrane
3
.
–
Add brake fluid up to the MAX marking
A
.
Brake fluid DOT 4 / DOT 5.1 ( p. 336)
–
Mount and tighten screw cap
2
with the shim and mem-
brane
3
.
–
Position the screw cap lock and mount and tighten screw
1
.
Guideline
Screw, brake
fluid reservoir,
rear brake
M5 3.5 Nm (2.58 lbf ft)
Loctite
®
243™
Info
Use water to immediately clean up any brake fluid that
has overflowed or spilled.
To Next Page
Loading...
