KTM 690 LC4 2007 - Preparatory Work; Left Side of the Engine

Preparatory work
– Thoroughly clean the outside of the engine.
– Drain the engine oil.
– Clamp the engine in the engine work stand 560.12.001.000 with
holders 750.12.001.060 and 750.12.001.070.
Left side of the engine
– Remove both screws 1 on the starter engine and dismount the
starter engine.
– Remove the valve cover screws and lift off the valve cover.
– Remove the screws on the generator cover
2 and lift off the
generator cover. Pull out the centering sleeves, remove and discard
the gasket.
– Remove the gear sensor
3.
– Remove both contact bolts
4 and the O-ring 5.
– Take both contact springs
6 out of the bores.
4-2
Repair manual KTM 690 LC4 Art.-No. 3.206.045-E
1
2
3
4
4
5
6