KTM 690 LC4 2007 - Moving the Engine to Tdc

– Remove the gasket and discard.
– Loosen the screw on the water pump wheel
1 and remove.
– Remove the water pump wheel.
– Take the washer
2 off the water pump shaft.
– Remove the screws and take off the clutch cover
3, discard the
gasket and pull out the centering sleeves.
– Unscrew the temperature sensor
4 (A/F 19 mm) and spark plug 5
(750.29.172.000).
Moving the engine to TDC
– Remove the plug 6.
– Turn the crankshaft in a counterclockwise direction until the mark
on the camshaft
7 is in alignment with the mark on the camshaft
retaining bracket.
NOTE: the mark on the camshaft retaining bracket is in the middle of
the screw
8.
– Screw on the engine locking screw 773.29.010.000, make sure the
engine is locked.
! CAUTION !
D
O NOT USE THE LOCKING SCREW TO HOLD THE CRANKSHAFT WHEN YOU UNSCREW
OR TIGHTEN THE NUTS ON THE FLYWHEEL OR PRIMARY PINION SINCE ENGINE PARTS
WILL BE DAMAGED
.
4-4
Repair manual KTM 690 LC4 Art.-No. 3.206.045-E
1
2
3
4
5
6
7
8
9