KTM 690 LC4 2007 - Removing the Rotor; Removing the Timing Chain and Timing Chain Pinion

Removing the rotor
– Hold the rotor 1 with special tool 750.29.091.000 2 as shown in
the photo.
– Unscrew the nut (A/F 27) on the rotor.
NOTE: make sure the crankshaft is not locked with the locking screw.
– Remove the nut and lock washer.
– Screw special tool 584.29.009.000
3 onto the rotor.
– While holding the special tool, turn in the screw; this will pull the
rotor off the crankshaft.
– Remove the rotor and unscrew the special tool.
Removing the timing chain and timing chain pinion
– Remove the screws 4 on the timing chain guides.
– Lift the guide rail
5 out of the clip 6.
NOTE: the sleeve
7 is inserted through the guide rail and clip.
– Lift off the guide rail.
4-7
3
4
4
5
6
7
1
2