KTM 690 LC4 2007 - Removing the Starter Drive; Disassembling the Shift Mechanism

– Turn the freewheel gear 1 in a counterclockwise direction and
remove the primary pinion.
Removing the starter drive
– Remove the lock rings 2 with the washers mounted underneath.
– Pull off both starter drive idler gears; remove the needle bearings.
– Take the freewheel gear 3 off the crankshaft and remove the
woodruff key
4.
– Remove both needle bearings
5.
Disassembling the shift mechanism
– Push the shift rail 6 away from the shift lock 7 and pull out the
shift shaft
8 together with the washer mounted underneath.
– Remove the screw
9 (AH 5 mm) on the shift lock.
– Press the locking lever
bk down to relieve the shift lock 7, remove
the shift lock.
– Loosen the screw and remove the locking lever together with the
washer and spring.
4-10
Repair manual KTM 690 LC4 Art.-No. 3.206.045-E
1
2
2
3
4
5
6
7
8
9
bk
7