KTM 690 LC4 2007 - Clutch

5-16
Repair manual KTM 690 LC4 Art.-No. 3.206.045-E
Clutch
– Check the pressure piece 1 for seizing marks and smooth operation.
– Check the axial bearing 2 for damage.
– Lay the pushrod
3 on a level surface and check for runout.
– Check the length of the clutch springs
4. Minimum length 31.5 mm (33.5 mm new), replace all 4 springs if necessary.
– Check the pressure cap sealing area
5 for damage.
– Check the contact face
6 of the outer clutch hub for wear. If the indents are bigger than 0.5 mm, replace the lining disks and
the outer clutch hub.
– Check the needle bearing
7 for seizing marks and damage.
– Inspect the lining disks
8 and clutch disks 9 (see next page).
1
3
4
5
6
7
8
9
2