13 SERVICE WORK ON THE CHASSIS
164
13.6 Removing the passenger seat
K01359-10
–
Insert the ignition key in seat lock
1
and turn it clockwise.
– Raise the rear of the passenger seat cover, push it toward the
rear, and remove it upward.
– Remove the ignition key from the seat lock.
Info
The vehicle has been set up in the factory for one-
person operation. Only an authorized KTM workshop
may carry out the conversion.
The components for one-person operation and for oper-
ation with a passenger are included in the scope of
supply.
Always ensure that the legal requirements are observed,
e.g., entry in the vehicle documents if applicable.
To Next Page
Loading...
