SERVICE WORK ON THE CHASSIS 13
165
13.7 Mounting the passenger seat
K01360-10
–
Hook holding lugs
1
of the passenger seat onto the storage
compartment, lower the rear and push forward.
– Press the passenger seat downward until it clicks into place.
Warning
Danger of accidents The seat can come loose from the
anchoring if it is not mounted correctly.
– After assembly, check whether the seat is correctly
locked and cannot be pulled up.
– Finally, check that the passenger seat is correctly mounted.
Info
The vehicle has been set up in the factory for one-
person operation. Only an authorized KTM workshop
may carry out the conversion.
The components for one-person operation and for oper-
ation with a passenger are included in the scope of
supply.
Always ensure that the legal requirements are observed,
e.g., entry in the vehicle documents if applicable.
To Next Page
Loading...
